 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
89 B250 I cannot find ignition control module
I looked everywhere on the firewall, I took off the whole computer, and opened it up inside nothing remotely even looks like a ignition control module, I have looked in looked for weeks, still nothing, I know it has 2 screws, nothing of it on the firewall. Need help please.
|
||||
Check out some similar questions!
Hi Everyone, I am trying to replace the ICM but I'm stuck. Cap's off, shield's off, rotor's off tried to remove screws holding plate which is blocking the screws holding the ICM. Is it better for me to just remove the whole distributor? Afraid of destroying the screw heads. Also there is also...
I have a Lennox furnace with a Johnston Control ignition control G600ax-3 which I am unable to locate to replace. I ordered a universal White Roberts 50D50-843. The G600ax-3 has a spark igniter connection similar to a spark plug connection and the WR is a spade connector, do I have to replace the...
My problem with my Lennox furnace (model G23Q-3/4-100-2) is blowing cool air, and only occasionally heat was diagnosed as needing a Universal Pilot Module, part #53L9001 also known as 53L90. Question, if we purchase the part how difficult is the installation?
I would like to know where is located the computer of ford mustan 1992
I have a 1991 Ford Ranger 4 wheel drive with the 2.3L 4 cylinder engine. It has new wires, coil packs, and crank shaft position sensor. There are no burnt wires, fuses, or fusible links. There are also no chafed, pinched, or loose wires or connections in the harness yet I keep burning the Ignition...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
