Ask Experts Questions for FREE Help !
Ask
    jagkaru's Avatar
    jagkaru Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 13, 2010, 05:59 AM
    How can I load a drawing
    Hi, the capacitor wires to my fan got accidentally disconnected and I need help to fix them back.

    The fan has two wires (blue and brown) connected to the first and third screws of a plastic wire connector. A red wire connected to the other side (going out) of the blue (neutral) wire is going into the fan motor. A yellow wire from the fan motor is connected to the second screw of the connector. The brown phase wire is connected to the third screw of the connector. A green wire from the fan motor as well as the two wires from the capacitor are free. These three are my problem. Where do I connect them? Could someone help me please? I am enclosing my email address below so that you can any more information. I can send a simple diagram which I have drawn explaining the problem if needed.

    Thanks
    jagkaru[email protected]
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Jun 13, 2010, 06:27 AM

    To post a picture

    Upload picture to computer, convert to JPEG format.

    When posting response click on "Go Advanced " button below.

    Scroll down and click on "Manage Attachments"

    Browse to find picture, click "Open".

    Click "Upload"
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How can I load a drawing [ 0 Answers ]

Hi, the capacitor wires to my fan got accidentally disconnected and I need help to fix them back. The fan has two wires (blue and brown) connected to the first and third screws of a plastic wire connector. A red wire connected to the other side (going out) of the blue (neutral) wire is going...

Kenmore front load washer won't agitate/spin if load too heavy [ 2 Answers ]

My Kenmore front loading washer, model 417.43042200, won't agitate or spin to complete the cycle if the load is too heavy, such as 5 bath towels. If I take off the back and help turn the drum in the agitate or spin mode it will agitate/spin and complete the cycle. The pump still drains the tub. If...

Kenmore elite front load heavy load not spinning [ 0 Answers ]

My Kenmore Elite HE3 (model 11042832200) recently started having problems with heavy loads. I had a load full of towels and it wouldn't rinse/spin or drain/spin. I cancelled the cycle and took out most of the towels and it did a rinse/spin with no problem. I ran smaller loads and they completed...

277/480 load after transformer = to 120/208 load feed [ 1 Answers ]

I have a 800 amp 120/208 3P stand up section that feeds a step up 90kva transformer and the loads are nearly equal? I thought that after the transformer the load of 277/480 would be drawing less. We have about 500 amps per phase being drawn in front of the transformer and the load at the sub...

View more questions Search