Ask Experts Questions for FREE Help !
Ask
    johndouglas's Avatar
    johndouglas Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 8, 2010, 07:59 AM
    Heil sp80, blower motor fails to run
    I own a Heil SP80 residential furnace. Just recently, I noticed the blower motor(room air circulation) failed to run after the furnace ignited and heated the heater box. When I manually rotated the blower motor fan to get it started the blower motor would run on its own but only at low speed... I believe it is a 2 speed blower motor fan when operating normally. Is there a start-up capacitor in series with the motor wiring that could be causing the problem? Or should I be looking to replace the motor.

Check out some similar questions!

Heil SP80 Draft Inducer Motor Cycling On/Off [ 1 Answers ]

Hello, I have a Heil SP80 natural gas induced draft fan furnace, model # NUG5075BFB2. The unit fires up normally and all is well until the unit shuts off when the temperature setpoint is reached. The draft inducer motor then cycles on and off shortly after the flame is shut down and for 20...

Goodman furnace will ?heat motor? And blower motor will run but not at same time [ 2 Answers ]

I have a 2 year old Goodman, gas, no heat pump. There is a flashing LED that blinks once ever 4 seconds. Also, blower motor does not stay on always. We did smell something like an electrical burn. I'm guess my blower motor is fried?

Heil SP80 Won't Ignite [ 11 Answers ]

Last night when I went to bed the furnace was working fine. The power flickered on and off all night, and at 5 am I woke up freezing my butt off. It was 52 degrees in my house. I can hear it the furnace running, but it is not blowing any heat through the vents in my house, nor is it taking in...

Heil sp80 gas settings [ 4 Answers ]

Good Day: Our furnace is a Heil SP80 model #NU65100BFB2, 100K BTU output, converted to LP gas. The main gas valve failed (Honeywell SV9500M 2682, converted, dead solenoid) We have just put in a new main gas valve (Honeywell SV9501 M2056), and personally put in the gas conversion from NG to...

Heil furnace fires up but blower motor shuts down [ 2 Answers ]

I have a Heil high efficiency furnace about 15 years old. Sometimes the burner will start and the exhaust blower then the blower fan will blow for a short time and stop. The burner will still be very hot. It used to continue to run until the furnace cooled down. What could be wrong?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.