Ask Experts Questions for FREE Help !
Ask
    caro5's Avatar
    caro5 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 6, 2010, 02:46 PM
    Concrete drive problems
    I had a new concrete drive installed 4 months ago, which has dried with a blotchy appearance. The colour of the drive is uneven, and in places the surface has a sandy like appearance. Presently there doesn't appear to be any pitting, but I am concerned about the durability of the drive. I wonder if the concrete was incorrectly mixed when it was being laid resulting in this messy and sub-standard finish. I welcome your comments.
    lineswine's Avatar
    lineswine Posts: 6, Reputation: 1
    New Member
    		  
    #2

    Jun 11, 2010, 06:10 AM

    Get onto your contractor... sounds like they've done a poor job
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cd drive problems/hard drive [ 4 Answers ]

I'm using windows xp pro I've got a lite-on combo cd drive :E Basically I tried 2 fix my e drive because it wasn't reading cds (on dvds) and I think I put a virus on my computer When I tried 2 restart it came up with something like.. Windows cannot start up properly due to a recent...

New Concrete Drive Problems [ 1 Answers ]

We recently had a new concrete drive installed and it looks like in some areas there are 'stretch marks'. Also, there are several areas where there are 'pock' marks and trowel marks. If they were to fill the wholes and grind down the trowel marks will this permanently fix the problem or will it...

Running wire under concrete drive using an existing plastic water line. [ 8 Answers ]

I have a broken neutral wire somewhere underground running from my house to my barn. It has an 70 amp circuit breaker in my house 200 amp service panel supplying a small panel in the bard. The run is about 200 ' using 2 gage aluminum three wire, no ground. Since I have to bury new lines, I...

Concrete problems [ 1 Answers ]

I just had a cement patio poured 21x24 it was tinted to match our brick on our house. It has been two days since they finished and there are several uneven areas. In ideas on how it could be fixed. Is it possible to get more concrete and pour over the top and redone. That is a thin layer? Any...

Concrete floor installation problems [ 5 Answers ]

A plumbing contractor had to dig up the floor in my bathroom, then reinstall the concrete floor. The initial floor installation was not level and had a hump in te middle. The first attempt at correction was to pour a small amount of allegedly self-levelling concrete, which was badly poured, with...

View more questions Search