Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
York Diamond 80 heat blower cycles 20 seconds
[ 9 Answers ]
Hi, I have a 1996 York Diamond 80 furnace. Everything starts up OK (thermostat fine, flue fan kicks on fine, then pilot orange glow, then click, then gas burners fire up, then main blower fan starts). This all happens in about a minute or so, but then the main fan only runs for 22 seconds, then it...
2001 York diamond 80 HVAC blower fan stops after 20 seconds (not in heating/cooling)
[ 2 Answers ]
Just had the HVAC serviced (inspected) by firm that tightened loose wires outside, checked outside unit and inside blower, noting only slight dirt buildup on blower. Unit ran fine during tests. Next day, 2001 York diamond 80 HVAC blower fan stops after 20 seconds in the on position (not in...
York diamond 80 blower works but no heat
[ 1 Answers ]
the blower turns on and blows cont. but the burners don't kick on the blinking red light on the box blinks 4 times = high linit switch on
Where to find an aux spill switch for york diamond 80 furnace
[ 36 Answers ]
I have an error code that says the aux spill swich is open, But I think it is just going bad because it works sometimes and may be getting ready to go bad. Where to find an aux spill switch for york diamond 80 furnace?
York Diamond 80 Ignitor works abd blower runs but does not heat up house
[ 3 Answers ]
Our basement unit York Diamond 80 runs and run with the ignitor working and the blower running but does not heat up the first floor. The unit in the attic heats the first floor fine. The exhaust vent seems to be extremely hot. Is it possible the motor that exhausts the cabon monoxide from the gas... View more questions Search
|