Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
2/0 GA wire splices, safe? Pass inspection?
[ 7 Answers ]
Help please... I am wiring a mobile home from the main breaker box inside to the power pole (200 amp) outside. The mobile home movers cut my wiring where it comes out underneath the home. I have used the aluminum splices that tighten down with allen screws and then wrapped them with about a half a...
Will this rough in pass inspection?
[ 10 Answers ]
Hi, Doing an extensive DYI rehab on a single family home in NJ. The short question is does this look like it will meet code? The Galvanized Pipe and the cast iron stack it is attached to will be removed when I get this hooked up. My concerns are: I did not put a vent up on the tub on the right...
Will my truck pass inspection?
[ 8 Answers ]
About a month ago, my truck started making this weird noise. I took it in to the garage, and they told me one of the axles was broken, but it would be OK to drive until I could come up with the money to get it fixed. I finally was able to take it to get a fixed a week before christmas, but I had to...
Vehicle Inspection at Other State
[ 6 Answers ]
Hi, I have MA license plate but currently living in PA. My vehicle inspection expired yesterday (August 08) and need to get new one. Can I just go into any PA inspection site and replace it with PA sticker? I don't think I'll be back in MA for awhile, but I may be moving to California soon... View more questions Search
|