What size allen wrench is needed to remove screw 76713 on K-10412

tram66 Posts: 1, Reputation: 1

New Member

May 10, 2010, 09:08 AM

What size allen wrench is needed to remove screw 76713 on K-10412

What size allen wrench is needed to remove screw 76713 on K-10412

ballengerb1 Posts: 27,378, Reputation: 2280

Home Repair & Remodeling Expert

May 10, 2010, 09:16 AM

If this is a Kohler faucet try a 1/8" Allen

Add your answer here.

Check out some similar questions!

GE Oven Power Cord Attachment Screw Size? [ 3 Answers ]

Hey everybody! Ok, I have an older GE Oven, model number jbs030k1ad. The power cord attaches with 3 screws.. I just need to know what size these screws are! The company can't tell me because "its an old model". Neither can Sears, Lowe's, HomeDepot or the local hardware place. If...

Allen Wrench stuck in garbage disposal [ 2 Answers ]

Please help! Our garbage disposal would not turn on, but just made a humming sound. So I took an Allen wrench and inserted it into the hole at the very bottom of the unit and turned the wrench. This freed up the unit... and it would be operational now, but the Allen wrench got stuck in the bottom...

Trying to remove spout from body on kohler k-10412 [ 5 Answers ]

Hi I am trying to replace o rings and bearings from a kit kohler sent me for a leaking faucet. I have removed handle bonnet and valve no problem The instructions say "Hold the base of the spout and pull up to remove spout from body" when I try to do this it comes up approx 1/4" and then stops I...

How to remove a stripped screw [ 21 Answers ]

I am trying to replace a deadbolt lock and one of the screws will simply not come out! I am afraid that the screw is stripped. Any suggestions for its removal will be appreciated. Thank you.:confused::p:o

Wrench Size for JD GT245 Mower Blade? [ 2 Answers ]

Hi Folks, Can anyone tell me what size wrench to use to remove the three John Deere GT245 mower blades. It is close to 3/4", but that size is a bit large. 11/16" is a bit small. Could it be 18 mm? Also, I am supposed to turn the bolts Counterclockwise, right? :) Thanks for your help. ...