 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Can I wire my PR180 Leviton 3-way on line hot side?
Hi all,
My wiring set up is opposite that in instructions, in that I wish to replace the 3-way switch that is on the line hot side, not the load hot side. I found one post that said it could be done but the wiring diagram is missing or link is broken. Can anyone help? |
||||
Check out some similar questions!
Hello, I purchased the Leviton PR180 to wire into a 3-way switch installation. My setup is exactly like the wiring diagram in the instructions, but I cannot get the #1 switch (original 3 way switch) to turn the lights on after the motion detector has timed out and turned off the lights. I...
Hi everyone, This is my first question on the forum so here goes... A while back I installed a Leviton PR180 Motion Detector Light Switch in my laundry room and it worked beautifully. Earlier today I installed a 2-bulb fluorescent fixture in place of the incandescent fixture and this is...
I just did a single pole installation with a PR180. It turns a light and fan on in my bathroom. The wiring appeard simple black to hot, red to load, yellow/red not used, green to ground. The fan and light work great in the on position but in auto they are getting half the normal voltage. Is this a...
I purchased the Leviton PR180 and I would like to know if I can install without the switch. Could you please send to me the diagram? Thanks in advance, Marcelo Tralhao
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
