Ask Experts Questions for FREE Help !
Ask
    dpiranha's Avatar
    dpiranha Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 7, 2010, 01:25 PM
    Well pump problems
    I have a shallow well jet pump with an old galvanized tank. I've primed the pump and started the pump up. There is no pressure at first. I pull the supply line from the well up and down and pump water into the pump. The pressure goes up to 60 psi. My supply line has water. The pump was set at 50 psi and does not shut off. When I disconnect the power, the pressure drops to 0 psi instantly. I have checked for leaks. Can not find any. Any suggestions? Could it be a bad tank?
    shaneshot417's Avatar
    shaneshot417 Posts: 17, Reputation: 1
    New Member
    		  
    #2

    May 21, 2010, 04:38 AM

    The check value is stuck open. Replace value
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #3

    May 21, 2010, 06:03 AM

    I agree! If you have found no leaks in the suction line then the check/foot valve must be at fault.
    Replace it and let us know if you hold pressure now. Good luck, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heat pump problems [ 1 Answers ]

Bryant heat pump, model# 582ANW030060AAD The air conditioning works fine but when I turn the unit to heat the unit comes on but no heat is pumped through the ducts. None of the ducts are blocked, the AC pumps cold air through just fine and all the filters are clean. What should I do?

Heat Pump Problems [ 2 Answers ]

OK, I have a 10-year old Carrier Heat Pump that started blowing the 5V (24V DC) fuse. The unit would operate OK on emergency heat mode, but not in "real" heat pump mode. A local HVAC tech isolated the problem to the reversing valve (the unit basically was blowing the fuse when it went into...

Problems w/ a 20/40 pump [ 6 Answers ]

The well comes on and then the switch won't let the pressure get to 40 without the points sticking and clicking causing it not to cut off. This is an electric water well with a 20/40 pressure switch. What could be causing this?

Heat pump problems [ 3 Answers ]

My upstairs unit is a heat pump. It is not yet 6 years old. Recently, it has been giving me problems. The blower will turn on, but it doesn't seem to put out heat or cold. Does that make any sense? We have had both cold days and hot days in the past few weeks. On the cold days, it can't seem to...

View more questions Search