Where is the flame sensor located on a Trane xe 6?

mumph32 Posts: 1, Reputation: 1

New Member

May 1, 2010, 07:01 AM

Where is the flame sensor located on a Trane xe 6?

I have a Trane xe 60 and think I need to clean the flame sensor. Where is it? Lame question, so many thanks!

Joshdta Posts: 2,549, Reputation: 45

Ultra Member

May 1, 2010, 07:53 AM

A small metal rod, located in the burner box oppsite of the ignitor

Add your answer here.

Check out some similar questions!

Trane xe 90 flame sensor or what [ 3 Answers ]

I just moved in and furnace ignites for about 15 seconds then goes out. I've researched everything I can. Even found the orange wire for the press. Switch had "fallen" off and thought it might have been the whole problem, but still the same thing. From what I found so far I believe it has to be...

Trane xc90 gas heat lights then goes off, have changed flame sensor [ 36 Answers ]

I have changed all of the sensors and then I thought it was fixed. It ran and stayed lit for about 30 min and then went right back to the same problem. It will light and then the gas shuts off after a few seconds. If I let it cycle through this 3 times and then it should go to the " lock out"...

Trane flame sensor [ 13 Answers ]

Thermostat call for heat. Ignitor fire and almost at the same moment the pilot flame lights. After a second or two it goes out. Where should I start? Thanks

Furnace Ignitor and Flame Sensor for Trane [ 8 Answers ]

An HVAC service provider says I need a new ignitor and flame sensor at $153 and $107 respectively. Is there a cheaper way? Also, he says that my 13 year old furnace has only another year, maybe. Does this sound right? I am a widow and I am wondering if he is trying to scam me.

Trane xe 90 flame sensor or what (again) [ 1 Answers ]

I took the advice from many and cleaned the flame sensor. The furnace ran for about two minutes this time with the burners going, then they went out and continues to be that way. Could it be something else too, or is it likely just the sensor needs to be replaced ?