 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore 110.62994101 Electric Dryer
I have a Kenmore Elite electric dryer . Model 110.62994101 the will not stay running after the start button is released. I am suspecting that a relay on a main board is bad. Or could there be a less expensive repair solution.
|
||||
|
||||
|
On older dryers, the latch circuit is made through the centrifucal switch on the motor, if your dryer shows a relay, I would note the wiring drawing. If the drawing depicts that that relay is for the latch circuit, then it is possible that it is bad.
Is there anything else wired in with the hold circuit? |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Where is the heating element located on a Kenmore Dryer, Model #110.86873100?:)
My dryer stopped heating although it runs. I confirmed I was getting 240volts at the source. I checked the continuity of the element, the thermal fuse and the thermostat and found that they were continuous. I have read that the thermistor might have something to do with it...
My 3-yr.old Kenmore Elite Gas dryer has been doing very odd things! After running a load, when the dryer shuts off, or I shut it off (clear it), the touch control panel goes dead. No lights are lit. If you push the touch pad for various cycles it will not do anything. You can also push...
I have an electric kenmore dryer, seems like it is not getting power. I have checked the breaker everything is fine there took off the back panel and have tested that it is getting power as far down the hot wire as I can check that leads to the blower motor. Even when you open the door there is no...
View more questions Search
|
