 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Whirlpool gas dryer model GGQ8858HQI. Heat will not come on intermittantly although cycle runs normally. Sensor pad (part 3976479) fell out some time ago. This part looks like it should have electrical connectors plugged into it although I took the back off the machine and could not see any loose...
Dryer drum rotates, and it responds to the "cycles" dial, but the heating element doesn't heat up. Is there a reset button somewhere, or do I need to replace the heating element, OR? Thank you.
Dryer will run for hours - no problem. Then, with a new load, when button pushed, it will not run. It turns on, but when button released, it stops. Appears cause may be overheating. It will run 3-4 hours later. Is this because it is overheating? What could cause of overheating be? Is it...
20+ year old front loader. Starts just fine with a new igniter, but after a few minutes igniter lights up, but flame does not start. The coils were replaced approx a year ago. Verified gas flow is good, and exit duct clean of lint. Ohmed out the temperature switch by the flame and it appears...
I have a five year old hotpoint gas dryer. My problem is when I start the dryer, it heats great. After about 4-5 minutes it stops heating. I ran the dryer empty with the vent disconnected... heated fine. Ran it with the vent hooked up, dryer empty... heated fine. Ran the dryer with a load of...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
