Ask Experts Questions for FREE Help !
Ask
    ARolinson's Avatar
    ARolinson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 12, 2010, 03:33 PM
    Bryant ac fan doesn't come on but does with heat?
    My Brant AC keeps freezing up. The inside blower motor will not turn on, but works fine with heat. The motor will not start if I spin it first and rotates with no resistance. If I turn the entire unit off for 10mins I can usually get it to start up, but in time it will not cycle the fan on again and it will freeze up in A/C mode. Any suggestions? Could the Capacitor be weak and not be giving the motor the juice it needs or is the motor just failing at times in the high cycle?
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Apr 12, 2010, 05:38 PM

    Sounds like the cooling relay went out of your control board.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant plus 90, no heat [ 0 Answers ]

I have a Bryant, day and night plus 90, model 398AAW048100D furnace. At first when I opened the top cover, I could see the pilot light on and it would click off after about 10 seconds, then relight again after another 10 seconds and continue to do this and never llight up burners or anything else....

How do I change the aux heat setting on my bryant a07045 with heat pump [ 1 Answers ]

How do I change the aux heat setting on my bryant a07045 with heat pump

Bryant +80: fan is fine, no heat. LED 1-3. Filters clean. What should I try next? [ 3 Answers ]

Have a Bryant 80 plus furnace. Fan works fine. But it's blowing cool air. I've changed the thermostat setting to have the furnace try and make the temp significantly higher than the current temp. The LED flashes 1 short, 3 long. Cleaned the filter. Air flow seems to be fine. Any clues?...

Bryant furnace fan cycles on 1 or 2 times for 2 or 3 sec. After heat cycle has ended [ 8 Answers ]

I have a Bryant furnace Mod. #394GAD024050 and after the temp has reached the set point and the furnace has cycled off the fan will come back on a couple of times for approx. 2 or 3 seconds. In the older furnaces with a machanical fan/limit switch some times the temp would creep up and cause the...

Bryant Plus 80: No Heat [ 19 Answers ]

Hi, We've been without heat all day now. This Bryant is 10 years old, it's an upflow 395CAV042091 model. Blower motor runs but there's no gas ignition. Filter is new a few days ago. The DSS (draft safeguard switch) contacts are closed, the PRS (pressure switch) contacts are open like they're...

View more questions Search