[srhutch]

I recently replaced the heating element on my dryer and now it won't start again I had to replace a part next to the exsaust thermatat it's a little white part that has two wires that hook to it when I run the dryer close get very hot I think the heating element is putting out too much heat since I replaced it and this is way the part keeps going is there anything I can do to stop this problem may try another element please e-mail me at [email protected] if any one has a clue

[stuartn]

Your house venting is plugged or restricted. Clean your venting or replace it. Also make sure you dryer is not pushed back to far and restricting the vent. This causes your thermal fuse to open and your dryer to be really hot.