Ask Experts Questions for FREE Help !
Ask
    Puffer's Avatar
    Puffer Posts: 3, Reputation: 1
    New Member
     
    #1

    Apr 8, 2010, 11:50 AM
    Engine cranks but will not start
    1993 GMC Safari 6 cyl Two Wheel Drive Automatic 150000 miles

    Recently got this van from my wife's Aunt. It ran perfectly until it was parked 6 months ago. It is a V6 model with fuel injection.

    The engine turns over but will not fire. Fuel filter was replaced and the gas was dumped before parking and 10 fresh gallons added yesterday. When the key is turned to the on position you can hear the fuel pump come to life so it is functional as well. Pressing on the Schrader valve indicates that fuel is making it to that point in the system as well, under decent pressure. After pressing the valve, the engine will start for half to a full second and die. Then back to turning over with no fire. I tried adding a fuel injector cleaner thinking they may have been clogged by sitting for so long. No change to the problem.

    Distributor has been checked as well and is functional. Spark plugs are in good working order and are receiving spark from the distributor. To be safe the ignition module was replaced today as well.

    At this point I am at a loss as to what to do next. Any suggestions would be greatly appreciated.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Apr 8, 2010, 12:19 PM

    Perform the tests in the link below:

    https://www.askmehelpdesk.com/cars-t...ml#post2123675

    Be sure to test all under hood and under dash fuses with a test light or multimeter. Remove and fully charge the battery--most auto parts stores will do this for free.
    Puffer's Avatar
    Puffer Posts: 3, Reputation: 1
    New Member
     
    #3

    Apr 8, 2010, 12:50 PM

    Thanks for the quick reply. Here are the results:

    1. Battery test passed.
    2. All fuses pass test with test light.
    3. CEL operates normally.
    4. Fuel pump is audible when key is put in On position.
    5. Don't have access to a code reader and the van is immobile so I can't run the DCT.
    6. Spark is good. ICM was replaced and there is no CPS in this vehicle.

    Any other suggestions?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #4

    Apr 8, 2010, 01:01 PM

    When was the last time that all of the spark plugs were replaced? Many people neglect the rear plugs. Only use the exact ACDelco plugs that originally came in the car.

    Replacing the ICM was smart.

    Clean the main ECM ground. Start testing key sensor reference voltages, as a proxy for testing the ECM. After that, consider replacing the coil packs and going over the electrical system very thoroughly.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #5

    Apr 8, 2010, 01:17 PM

    Ensure that the spark plug wires are in good shape and are not shorting out.
    Puffer's Avatar
    Puffer Posts: 3, Reputation: 1
    New Member
     
    #6

    Apr 14, 2010, 04:38 PM

    Managed to get the van running. Filled up the gas tank and brought it to my house, about 20 miles away. Ran fine the whole way but now the engine knocks when accelerating. Idle speeds are fine and very low acceleration there is no knock. The knocking keeps time with the engine. I replaced the spark plugs and wires no change. It sounds as if the knock is coming from the center of the engine. V6 by the way.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

92 civic engine cranks but it won't start! [ 104 Answers ]

Hello, I have a 92 civic dx manual with 188k miles My son drove it to School had it towed home. The engine cranks over but it won’t start. I’m not getting fuel over to the fuel rail. I have no pressure. I got no problem codes. Check engine light never came on.

Engine cranks but won't start 2003 olds [ 3 Answers ]

Engine cranks but won't start unless hit with starting fluid,2003 olds alero 3.4

Engine cranks but won't start [ 1 Answers ]

I have a 1999 chevy silverado 1500 with a 4.3 v6. The engine cranks but won't start. I've checked the fuel pump (works fine) . I used a volt meter to ohm the coil, it's OK. I did some voltage checks on the signal going to ICM and coil, they appear correct. It acts like it want's to start but...

Engine cranks but doesn't start [ 3 Answers ]

I have a 96 chevy express 2500 van vortec 4.3. The engine cranks but doesn't start. I can hear the fuel pump come on when I turn the key. It is getting spark also. Tried starter fluid and it still doesn't even want to try and fire with the starting fluid. I am stumped any ideas anyone? Ran fine the...

Engine Cranks but won't start [ 5 Answers ]

I drove my 97 eclipse gst with 53000 miles the other day and parked it shortly after. It would not start again. Engine would crank but would not start. I checked fuel pump, works when turning the key. I checked fuel rail and it is receiving fuel. I checked spark on all wires it is fine and plugs...


View more questions Search