Ask Experts Questions for FREE Help !
Ask
    cpa37's Avatar
    cpa37 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 5, 2010, 04:11 PM
    Lawn tractor spark plug wire boot
    I have a craftsman lawn tractor with a briggs & stratton engine. How can the spark plug wire boot be replaced?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Apr 5, 2010, 05:06 PM

    It takes some effort, but by grabbing the terminal you can continue pulling it through. Wires usually crimped and the wires aren't what you would normally think a wire is.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Spark plug wire popping off [ 10 Answers ]

I have a 2000 Civic CX, 125,000 mi and the plug wire on the #1 cyl. Frequently pops off. This happens as the engine approaches normal operating temp. If pushed back in place after engine reaches normal temp, it stays in place and runs fine until the next cold start. The occurrence is becoming more...

Lawn tractor - no spark! What now? [ 11 Answers ]

Hi. I have a Craftsman lawn tractor with a B&S Intek 18hp 31H777 engine. At the end of last season, I put it away as usual at the end of last season and now this season it won't start. I have no spark at all. I replaced the plug and tested again. No spark. I removed the kill switch...

Spark plug wire loosens [ 17 Answers ]

Hello. I recently tried to diagnose an ignition problem. I removed one spark plug and it looked fine so moved on to something else. I eventually fixed the problem but now the spark plug wire (boot?) keeps lifting about a 1/4 inch higher than the other three. I then screwed the spark plug in a bit...

Don't get spark from my spark plug wire [ 1 Answers ]

I get spark from my spark plug wire sometimes when I don't the jeep don't start Why I don't get spark sometimes?

View more questions Search