Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Rheem Model 81V52D Water Heater
[ 20 Answers ]
My water heater seemed to be running out of hot water sooner that normal. Since the elements have never been replaced , I thought this might be the problem. So I shut off the power, cut off the water supply to the heater and shut off the valve from the heater to the house. I connected a hose the...
Rheem model 81v52d
[ 2 Answers ]
Once I replace the lower element in my water heater how do I properly bleed air out so upper element doesn't burn out?
Rheem hot water heater model# 81V52D
[ 1 Answers ]
This morning there was no hot water and I checked the circuit beaker and it had been trip to off position. I turned the beaker to on position, smoke started coming from where the Main electric wire that runs down into the top of the water heater, then the water heater trip the beaker back to the...
Replace a water heater 120 element with a 220 element with proper wiring
[ 4 Answers ]
Can I use a 220 heating element in a 110 water heater as long as the wiring is for 220. We had a 40 gal water heater 220 volts in a weekend cabin with one shower a complete over kill. Want to replace with a 20 gal 110 water heater but to take advantage of the 220 wiring can I just swap out the...
Heating element in a Rheem CHA unit not coming on
[ 2 Answers ]
I have a 1983 natural gas Rheem CHA MDL# RGLA-125A-GR serial # CN4d102 F3884 9382. Started end of last winter the flame out / heat sensor would trip. I had a new blower motor put in for AC in the summer and I have not had an issue with the sensor all this winter, it seemed to pull all the heat out... View more questions Search
|