Ask Experts Questions for FREE Help !
Ask
    electromechanic's Avatar
    electromechanic Posts: 26, Reputation: 1
    New Member
    		  
    #1

    Apr 1, 2010, 08:16 PM
    Increasing flow in Moentrol
    I just had a new full bath added on and the original remodel, total gut. The plumber installed Moentrol shower and tub valves. It seems to take forever to fill the tub. Anyway to increase flow?
    CHayn's Avatar
    CHayn Posts: 177, Reputation: 10
    Junior Member
    		  
    #2

    Apr 2, 2010, 03:30 AM

    Moentrols have stops built into them. Take the trim plate off and make sure those stops are completely open. They look like little slot type screw heads.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Increasing the water flow of a Moen shower head [ 5 Answers ]

I have just installed new bathroom fixtures, Moen brand. I have tried to increase the pressure of the shower head. I have taken out the O ring in the top and I have unscrewed the face of the head. I have not been able to remove the head or remove the plastic in the neck. I don't want to break it...

Increasing drain flow in bath tub [ 2 Answers ]

I have a bath tub in my upstairs bathroom that does not drain properly. Due to the way the batroom was built it is impossible to get the proper pitch for the water to drain out fast enough. Is there a pipe fan that can be installed in the overflow pipe to increase the flow or any other suggestions...

Increasing air flow using duct fans with flexiduct [ 1 Answers ]

The two systems seem to not cool or heat the house efficiently. They indicators are the fuel cost is really high and the house is very difficult to heat or cool The second floor unit works better than the first by a little bit. Looking into this there is very little air flow from the registers...

Increasing pump output flow rate [ 1 Answers ]

I have a waterfall in my pool that runs off my main pool pump via a diverter valve. Is there anything I can do to increase flow rate over my waterfall? When the diverter valve is opened it allows water over the waterfall while still filtering water through the skimmers. With the diverter valve...

Increasing Hot Water flow in Shower [ 8 Answers ]

I am in a 4 year old home. The County Inspectors had done something in the kids' bath that only allowed lukewarm water to flow in the shower. Understand that this was done to prevent scalding water to flow on to the kids. I believe this is something to do with the Flow Valve or Cartridge or...

View more questions Search