Ask Experts Questions for FREE Help !
Ask
    jsdl's Avatar
    jsdl Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 27, 2010, 12:02 PM
    I have a duet dryer model gew9250plo that is not heating I have replaced thermistor,
    I have a duet dryer model gew9250 that does not heat. Have replaced thermistor, heater, thermal fuse, thermal cutoff and thermostat. What else could be wrong?
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #2

    Mar 27, 2010, 12:17 PM

    I would have first checked the power, breaker or fuse, it good there I would check the plug and make sure you have power on the back of the dryer. With everything else new, it probably the prob.good luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replaced heating element in Kenmore Dryer-don't know how to hook the wires up [ 2 Answers ]

I replaced the heating element but can't figure out where the wires go back? The manual doesn't say anything about the heating element. There are 3 wires and I replaced it from the front.:confused:

MAYTAG Model LDE490 dryer not heating up [ 1 Answers ]

Our dryer is not heating up. I can set the time, turn it on, the drum starts turning... everything is doing fine EXCEPT no heat. Any suggestions? I did check the circuit breaker AND the lint filter. I don't have a manual for this machine. Any available?

Whirlpool Duet Dryer Model GGW9200 Won't Start [ 3 Answers ]

Dryer was working fine until I put in soaked clothes in it. Soaked clothes was drying for 15 minutes. I manually Paused/Cancelled it, took out clothes to squeeze excess water out of them. Put them back into the dryer and it won't start. Door open light turns on fine. No LED display when...

Whirlpool duet dryer '07 model [ 1 Answers ]

The lite on the left bottom of the dryer is lit that says "control lock" which prevents the dryer from turning on, I cannot get it to shut off. Any knowledge on this? I do not have a manual. Thanks

View more questions Search