Ask Experts Questions for FREE Help !
Ask
    gkko's Avatar
    gkko Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 25, 2010, 06:52 AM
    Standard Furnace CUB100A948C4 shuting down, tries to will relight, but shuts down agai
    Standard Furnace model CUB100A948C4 Found the fan running continuously this morning with no heat. Turned heat off from thermostat, but blower kept running. Changed filter (per troubleshooting section) and put heat to the on position. Funace lit and ran until I lowered the temp on thermostat. When I tried to get it to run again (raised the temp again) it lit but kept shutting itself down right away.
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Mar 25, 2010, 07:50 AM
    Try cleaning the flame sensor. It is usually located and the end of the main burner assembly OPPOSITE the ignitor.
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I relight my furnace [ 1 Answers ]

It says aire-flo on the front of it and I don't know how to light it

Carrier furnace takes to tries to turn on? [ 1 Answers ]

Hello, on my furnace over the last two years I have had the gas pressure checked, the service line checked for moisture, replaced the regulator valve, replaced the thermostat, replaced the fan limit control switch, and replaced the 3 wire pilot burner. Problem was worse but seems to have gotten...

Pilot Relight module for old lennox furnace [ 3 Answers ]

Hi Everybody, Am planning to install a pilot relight module on my old Lennox model furnace with no motherboard . What kind of module Do I need to go through this process without having a motherboard . I have seens kind of a metal T stat located very close by the ignition module box which I...

Byrant Plus 90 furnace will not relight [ 6 Answers ]

I have a 1987 Byrant Plus 90 furnace. The other day the wheel on the inducer motor lost a couple of blades. I replaced it installed a new wheel and the motor. Plugged everyhting in but the pilot light would not stay lit. I removed the cover cleaned the pilot light area and the gas orfices. The...

Electric Furnace not shuting off? [ 4 Answers ]

I have a Duo therm electric furnace that wants to run all the time. Ive replaced the thermostat and that didn't help, The last thing I tried was completely disconecting the thermostat, it just for heat, two wires and there just hanging out of the wall and the furnace still runs and won't shut...

View more questions Search