Ask Experts Questions for FREE Help !
Ask
    ocken1's Avatar
    ocken1 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 22, 2010, 05:12 PM
    Ford FL3500 DIesel Engine problem
    I got a Ford FL 3500 Diesel Engine problem. Once I replaced injectors, solenoid switch, change engine oil, starter and alternator , fuel pump, batteries, all filters change. Thus problem as follow occurred:

    The diesel is not finished burnt in engine and turns to power. Speed and power is low cannot up to 100-km/hours. Plenty of black smoke and diesel is through exhaust pipe.

    Any want can help? Check from computer diagnostic , it shows no problem at all? Thanks for helps.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Mar 22, 2010, 05:35 PM

    Sounds like an air restriction. This link should help:

    https://www.askmehelpdesk.com/cars-t...ml#post1921427

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

2006 ford diesel engine problems [ 2 Answers ]

2006 f 350 diesel starts when cold and does not when hot and laso runs rough

Ford power stroke diesel engine [ 7 Answers ]

My 97 Ford f350 power stroke diesel quit on the way to work . The fuel filter was changed Then on the way home it quit again. After sitting for a little bit it started again. It will run good for about 15 minutes then shuts off. What could be wrong with it?

Ford f250 diesel problem [ 0 Answers ]

My 2003 6.0 diesel is getting some kind of power surge. Ill be driving along and all of a sudden its like I give it more throttle... just wants to accelerate on its own. It doesn't constantly do it. It may do it then 25 or 30 miles later it will do it again. Was wondering what would cause something...

Ford diesel 7.3 oil problem [ 3 Answers ]

I have a 2000 f-250 w/7.3 the gally plug o-rings keep blowing out anyone know of a problem that may cause this or if ford has a problem with the o-rings.


View more questions Search