Ask Experts Questions for FREE Help !
Ask
    kevin089's Avatar
    kevin089 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 22, 2010, 08:32 AM
    My craftsman 3.5 HP edger (mod # 53677210) will start only after I prime it 15 or mor
    My craftsman 3.5 HP edger (mod # 53677210) will start only after I prime it 15 or more times and then dies after it burns that gas, which takes all of 2 or 3 seconds. Checked the float bowl and it is clean. Put new gas in it, and because it started, I assume that the spark plug and wiring are all right. What should I do next?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Mar 27, 2010, 08:46 AM

    Check the bolt that holds the bowl to the carb , some of these have holes in them that's how the carb gets fuel.run a piece of wire up through the main jet.What engine is on this?
    Luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to adjust Craftsman Lawn Mower, Mod. # 917.274391 [ 4 Answers ]

I've got the manual and followed said procedure. Here's my issue>the FRONT part of deck is level side to side. BUT the BACK RIGHT side of deck is 1/2" HIGHER than the BACK left side. There is nothing in the manual that addresses BACK side to side discrepancies. What do I do? I'll be...

Craftsman edger will not stay running [ 1 Answers ]

Craftsman 3.5 edger starts when primed, but will not stay running. If I keep pushing the primar it will run until I stop pushing it. Could this be a fuel filter problem or due to old gasoline? Help!

OEM for Craftsman Chainsaw Mod # 917351472 [ 1 Answers ]

I need to find a manual for craftsman chainsaw model number 917351472

Craftsman drill press MOD 21334 off center [ 1 Answers ]

Cannot find reason for the slanted hole. All adjustments are set correctly, and everything looks square and normal.

View more questions Search