Ask Experts Questions for FREE Help !
Ask
    vkpartking's Avatar
    vkpartking Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 14, 2010, 08:08 AM
    Briggs and stratton carb issue.
    This tiller was toast. Cracked block,piston seized in its bore, gas tank full of water. So I welded the block, freed the piston, lapped the valves, replaced the head gskt. Cleaned out the tank, rebuilt the carb. (with new fuel pump,pick-up tube, mixture needle,and many hours of soaking.) Now it only runs on starting fluid. I also can keep it running by covering the intake then uncovering it when it starts to die. I tried the mixture screw in many positions, (even all the way out and in my hand) but this did not help it run on its own. I must be missing something simple!
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
     
    #2

    Mar 14, 2010, 06:41 PM
    The carburetor ahas many small vents and ports which are clogged. Try Bleach White, yes the tire cleaner on the carb, and use a very fine wire to probe every vent and orfice in the carb. And be careful, the Bleach White is caustic. When I worked in a small engine shop the symptoms you describe were 99% of the time a plugged carburetor. If you can't clean it out, it probably has some internal corrosion which indicates a replacement carb is needed... but don't give up easily, carbs can be a real pain.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs and stratton carb? [ 9 Answers ]

Got a murray push mower w/3.5 hp classic 9d902 2005 b2 00122851 b&s motor--primer bulb rotted away-installed new snap in bulb--opened up carb checked out for any gummy build up or bulb fragements -found none----primer won't squirt gas in carb unless you pour a little gas in carb--starts great then...

Carb settings on older briggs and stratton engine [ 3 Answers ]

I have a model 190432-2535 briggs and stratton 8 hp engine and I need help with resetting all three carb screws. Any ideas what they should be?

15 HP Briggs and Stratton, Oil in Carb [ 1 Answers ]

Briggs 15 HP OHV, Model 311707, type 0138-E1, code 010228ZE. 151 hours on engine. Large volume of oil being blown into carb/air cleaner. Heavy clouds of gray smoke. Oil level on dip stick normal. Engine loads up and dies. What are possible causes and solutions? Woodman 65

11HP Briggs and Stratton, gas blowing out the carb! [ 2 Answers ]

I've got a Briggs and Stratton 11 HP L head (horizontal) on a mower I'm trying to fix. When I check the valve clearance at 1/4" past TDC I have the correct clearance .007 (aluminum block), however, during the ENTIRE compression stroke, the intake valve is open a few hundreths and it's blowing...

Briggs and stratton carb problems [ 8 Answers ]

I have been having problems with my briggs and stratton 12.5hp motor! The carburator keeps getting too much gas into the float reservoir and gas comes out. I recently purchused a brand new carb and installed it but still seam to get too much gas to the carburator when I go to start it. Could it be...


View more questions Search