I am wanting to remove an Aqua Pex Angle Stop under a toilet, how do I do this?

david3by9 Posts: 1, Reputation: 1

New Member

Mar 13, 2010, 01:46 PM

I am wanting to remove an Aqua Pex Angle Stop under a toilet, how do I do this?

I have tried to pull the one piece angle stop and supply from the Aqua Pex to install a new stop. It will spin but I cannot remove it.

Check out some similar questions!

Angle Stop [ 1 Answers ]

Have you heard of an angle stop with a plastic knob that you should pull for water shut off to the fixture? My Mother has these in her house and can't seem to pull them out for water shut off.

3/8" PEX push-connect to 7/8" ballcock angle stop [ 5 Answers ]

Has anyone seen one of these: an angle stop valve with 3/8" PEX push-connect inlet and a 7/8" ballcock outlet? I'll take it with or without a riser. I could even work with a straight stop valve. Instead of 7/8" ballcock outlet, I can even work with 3/8" compression. Several outlet options here,...

How to remove camper toilet [ 1 Answers ]

I have a 79 winebago camper I am fixing up I need to remover toilet to redo bath but do not see any screws to access does anyone have directions on removing what I have been told are Marine toliets Thanks

Angle stop with PEX [ 8 Answers ]

I would like the easiest route from a standard angle stop to a copper pipe (then to PEX). This is for a toilet supply. I would like to use a standard angle stop and screw it to a copper pipe, and use Shark Bite or Watts quick-connect to connect it to the PEX. I want to avoid using another...

Angle stop [ 3 Answers ]

What is a standard 1/2" compression angle stop? I am installing a sink faucet supply line

View more questions Search

Check out some similar questions!

Add your answer here.