Preblower motor doesn't want to start on my luxair furnace

steveys Posts: 2, Reputation: 1

New Member

Mar 10, 2010, 03:33 AM

Preblower motor dosen't want to start on my luxair furnace

Preblower on my luxair gas furnace doesn't want to start

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Mar 10, 2010, 01:23 PM

Test motor and motor voltage supply. Replace proven defective component.

Add your answer here.

Check out some similar questions!

Furnace blower motor start and keeps running won't stop [ 12 Answers ]

I have a Carrier central furnace (furnace model 58GP050-BA). Now with the thermostat off the fan set to auto and the Gas pilot is on. When turn on the power switch to the furnace, the blower motor start and keeps running and won't stop. I have to turn off the power switch to the furnace to turn the...

Blower motor of Trane XE80 furnace won't start [ 8 Answers ]

I have a Trane XE80 gas furnace. The purge motor and burner go on, but main motor won't run. LED flashing light flashes continuously when burner is on however, when the burner shuts off, the LED light flashes 4 times at an interval. I tried to look for a reset button on the main blower motor but...

Why doesn't my furnace start up? [ 1 Answers ]

Why dosen't my furnace start up? Can a thermostat be bad even though it appears to work? Pilotstat has been changed New thermocoupler installed Pilot light light up OK When thermostat is turned up you hear a click but furnace burner dosen't light up. What is the...

Luxair furnace running but not heating [ 1 Answers ]

I have a luxair PBLU-LD14N100A the combustion blower runs but the gas will not engage. If I fiddle with the vacuum switches I can get it to fire up for about thirty seconds, then I goes back to where it was. I also get the same result if I pull the hose from the combustion blower (The hose that...

Furnace motor has power but won't start [ 2 Answers ]

My furnace motor will not start, however if I give it a gentle turn by hand (via the fan), it starts right up and runs fine. Is the is capacitor or a switch problem in the motor? Thanks...