 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Basement plumbing vent
I wish to add a basement 1/2 bath consisting of a WC and a vanity. It will drain into a 4" vertical Cast Iron waste stack. I am going to break up the floor and wish to tie into this waste stack. How would you tie into and with what material? Can I wetvent the WC through the sink? Can I use a Automatic air valve to vent this group? How high and where would you place this AAV? Thanks for any info.
bman55 |
||||
Check out some similar questions!
I built a bathroom in my basement... shower, vanity, and toilet. I had to buy a pump from Lowe's designed for this renovation. For it, I had to build a raised floor for the installation. The pump is designed to attach to where the toilet sits. My main sewer drain is about 5' up the wall behind....
This is going to be a mess I can see it all ready. Here it goes. I have planned out my basement and I am putting a full bathroom, washer and kitchen in. I am planning on cutting the vent through an existing upstairs closet (so I can hide it and later frame a plumbing chase around the pvc). The...
I want to install a 1/2 bath on the main floor of our house. I have a 3" drain coming out of the basement floor that serves the washer and will serve the 1/2 bath. My question is venting the 1/2 bath toilet, lavatory, and washer located in the basement. Can a 3" elbow with a 2" side-inlet to...
Does anyone know how I can get my plumbing tube vent through a 2x4? Thanks in advance.
1)Combination waste and vent has a vent pipe which runs horizontal for 15ft and than rise up through roof. UPC does not have any paragraphs to object this. Does anybody know what the risks are. THis is a system serving to one floor sink only with 2" tail pipe and 3" waste line.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
