Ask Experts Questions for FREE Help !
Ask
    joelcanoy's Avatar
    joelcanoy Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 24, 2010, 08:34 AM
    Installation of balancer shaft
    What is the proper installation of balancer
    joelcanoy's Avatar
    joelcanoy Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Feb 24, 2010, 08:40 AM
    Installation of balancer shaft
    Hi to all
    Anyone who can assist me with my problem? I am having a camry car that having a problem on timing mark for balancer shaft, I would like to pinpoint the exsact location of pin mark before procceding with the installation, in either for me to make it sure that I install the parts properly.

    Thanks to anybody who can advice in regard to this matter.
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
    		  
    #3

    Feb 24, 2010, 08:31 PM
    Well Joel, This should help, but you didn't say what year so I took a stab. There are spacers, or I like to call shims between the block and the BS housing.
    This properly sets the backlash. Re use those just as it came apart and all should be OK.
    balance shafts.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Harmonic balancer [ 3 Answers ]

How do I change the harmonic balancer in a 1993 buick 3.8

Buick 3.8 Harmonic Balancer [ 3 Answers ]

It's ready to pull, so I can get to the crank sensor. Bolt out etc. It has a 3 small slots for a puller to get into. Well I have an assortment of 3 jaw pullers 3" being the smallest. No way!! Do you guys have one that has a part number I can get one?? Do they make a 2" or what? Snap On...

Harmonic balancer [ 3 Answers ]

How do I get the harmonic balancer off my ford ranger, to replace it?

View more questions Search