 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Electric choke cap
I have an edelbrock 1406 carburetor that I rebuilt,and I can't seem to get the choke cap installed the right way.so can anyone please give me a step by step info on how to install and adjust the choke cap.any info would be very helpful. THANKS
|
||||
Check out some similar questions!
Hi all, Unsuccessfully tried to cap a copper water line by soldering a pre-soldered cap onto the end. Took all the proper steps, cleaned the ends of the pipe and fitting first, then applied flux around both. Wasn't quite sure what I should be heating, so I just heated everything. After my first...
The choke on my Snapper Lawn Mower sticks. Any advice on how to get the choke to release?
I have a sears lawn tractor. Lately every time I try to start the choke is stuck. What can I do? How do I replace the choke?
Hi. I have a briggs & stratton 4 hp engine on a wood chipper, it runs but need to leave the choke on full to keep it going. What is the problem Thanks Keith
Hi there, I am trying to fix an old Goettl gas pack unit. It worked fine till 2 weeks ago. Now it starts normally with colder air for like 4-5 minutes then it sends inside warm air , no cooling . From outside I can see the condenser fan blade starting to rotate for those 4-5 minutes , low RPM...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
