Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Water heater leak (cold side only) where the nipple meets the water heater
[ 9 Answers ]
I just bought a water heater and completely installed it. When I turned on the water supply, a very very very slow drip can be observed where the cold water nipple screws into the water heater. I shut off the water, relieved the pressure and unscrewed the nipple. I then re-apply the teflon tape...
Max Distance for Gas Tankless Water Heater Venting
[ 14 Answers ]
I am considering purchasing a gas water heater but have some concerns about the venting. Everything I've read seems to indicate that the heater vent must exit the house within 10' of the heater. Due to my home's configuration, the minimum distance is about 25'. Am I totally out of luck? Are...
Hot water heater venting
[ 1 Answers ]
Can flex pipe be used to vent a gas hot water heater. I need to move the existing vent by two feet and flex would be easier. Thanks
Connecting a tankless water heater and separate hot water heater
[ 6 Answers ]
What I have is this. An oil fired boiler that generates hot water for my house baseboard heating system. Contained within the boiler is a tankless heater that is heated by way of the firebox in the boiler. The tankless heater is used only for domestic hot water. It has a separate CW supply to the...
Tankless Water Heater venting
[ 3 Answers ]
Hello, Can anyone tell me why you need to use stainless steel pipe for venting on a tankless gas water heater. What would happen if you connected to existing galvanized steel? Any info would be appreciated. View more questions Search
|