Ask Experts Questions for FREE Help !
Ask
    rasparson's Avatar
    rasparson Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 22, 2006, 12:00 PM
    Replaced air pressure switch
    My Goodman Gas Furnace diagnostic light indicates a faulty air pressure switch or restricted air supply vent. Vent appears clear, vent motor assembly works. I replaced the air pressure switch but the diagnostic light still indicates the same problem. Is there a reset switch or means of resetting to clear the computer or integtrated circuit board to clear the default reading?
    juggallojed's Avatar
    juggallojed Posts: 165, Reputation: 10
    Junior Member
     
    #2

    Nov 23, 2006, 10:10 AM
    Quote Originally Posted by rasparson
    My Goodman Gas Furnace diagnostic light indicates a faulty air pressure switch or restricted air supply vent. Vent appears clear, vent motor assembly works. I replaced the air pressure switch but the diagnostic light still indicates the same problem. Is there a reset switch or means of resetting to clear the computer or integtrated circuit board to clear the default reading?
    Try clearing the port where the pressure tube connects to the draft assembly , sometimes a little rust or debris gets in there.


    Also the tube may have water in it so clear that too

    Power off for 10 seconds to remove fault code.. it will not reapear unless the fault occures again

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace won't stop blowing air - replaced the thermostat [ 4 Answers ]

I have a Janitrol U-29A that is probably about 8 years old. I don't when it started, but sometime over the summer it began acting up. The blower does not stop blowing air unless I turn off the furnace at the circuit breaker. The AC unit outside turns on and off through the thermostat, but the...

Fresh Air Switch [ 2 Answers ]

Hi, We recently bought a home with a Coleman Evcon electric furnce. It seems to run fine, but we noticed there is a switch labeled fresh air that is off. I am not sure what this switch is for & I do not have an owners manual for the furnce. Can anyone tell me what the switch is for & what it...

Limit Switch - Pressure Switch [ 0 Answers ]

Hello Folks, This weekend I've been playing with a heating system at my new apartment and I'm trying to figure out what the different componets do. I kind of followed the circuit but still have some missing links... 1-There are some terminals on the furnace's circuit board labeled LIMIT. The...

No water pressure after pipe replaced [ 1 Answers ]

Hi--we had a leak in a hot water pipe in our basement--after the pipe was replaced we have lost our hot water pressure. The pipe is more narrow than the pipe that was originally there, could that be the problem?

Well Pressure Switch Help! [ 2 Answers ]

I have decent pressrue in the house, but I did not hear the pressure switch kicking on and off as it used to. I went out side and checked and the switch points are staying closed, and the pump is running all the time. I can shut off the electric, and open the points by hand, then when I turn on the...


View more questions Search