Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
How to solder tail pipe onto drain pipe
 [ 2 Answers ]
 I have a 1 1/4" drain on my bathroom sink. It goes into the wall and soldered on to a cast iron elbow. My chrome pipe is leaking and needs to be replaced. What alternatives do I have besides tearing the wall down to repipe? 
Ok to tie a wet bar drain into a drain pipe coming from 1st floor.
 [ 6 Answers ]
 I'm finishing my basement in a newer house and want to add a wet bar. There is a 2" PVC drain pipe coming from the 1st floor that is for the washing machine drain. It has a clean out plug on it also. Can I just add a wye or Santee for the bar drain and do I need an Air Admittance Valve for venting.... 
Vent pipe turned into drain pipe and drain pipe into vent pipe
 [ 3 Answers ]
 I recently began to remodel my laundry room. I wanted to move the washing machine 3 ft from its current spot. When I removed the sheet rock I found that the vent pipe is between the current washing machine drain and where I am moving my washing machine. I wanted to avoid breaking into the slab.... 
Tapping in new drain pipe to old sewer pipe
 [ 2 Answers ]
 I want to install a new tub and shower in my basement. The old shower in the basement drained through a pvc pipe that ran on top of the basement floor directly to our floor drain. I have excavated a channel from the proposed tub site to the sewer pipe running from the first floor toilet to the... 
Bathroom sink wall pipe drain pipe
 [ 2 Answers ]
 
My house was built in early 70's.. No plastic.. I'm putting in a new sink and had to remove the wall pipe that goes into the wall.. I needed a longer one. It seem where it goes in behind the wall into the plumbing there was some type of gasket as pieces of it fell out when I removed the pipe.. I... View more questions Search 
  |