Ask Experts Questions for FREE Help !
Ask
    rayf's Avatar
    rayf Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 22, 2010, 07:23 AM
    Beckett nozzle line
    Hi!

    I am looking for a nozzle line for a Beckett AFG Type F Oil Burner with a 5inch air tube.
    If you can’t get that part alone then please send price and what is included.
    The nozzle tube is an “L” shaped aluminum oil line that fits into the nozzle housing located under the electrodes.

    If you can’t get the part, could you tell me where I might be able too?

    Ray
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 22, 2010, 05:57 PM
    Usually those lines are steel
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Oil burner nozzle drips [ 1 Answers ]

My burner nozzle drips oil after it cycles off. We have replaced the filter and nozzle. We have also installed a new aquastat as the furnace was not restarting all the time.

My beckett fuel pump does not supply fuel to nozzle [ 1 Answers ]

I get fuel to my fuel pump but the fuel does not come out the supply side were the nozzle line connects to

Beckett nozzle [ 5 Answers ]

Where can I buy a nozzle for a beckett oil burner? Does home depot or Lowe's carry parts?

Beckett AFG WL-4504 nozzle choices for f4 head [ 5 Answers ]

I have a Beckett AFG model WL-4504 burner, Weil-McLane WTGO-4 oil boiler that runs a f4 head. The specs call for a 1.25X80B nozzle with 100psi pump pressure. What I found in my boiler was a .75X80A nozzle. I have not verified pressure yet. The shutter is set to 2 and the band to 0. Specs call...

Drain king nozzle stuck [ 4 Answers ]

Drain king nozzle stuck in straight pipe 8" down from kitchen cabinet floor, seems to be some ridge that I can't pull the nozzle back through........ I cut the pipe under the sink to try to get to the nozzle and that is how I was able to measure how far down the obstruction is..........if i cut...

View more questions Search