Ask Experts Questions for FREE Help !
Ask
    krockneedshelp's Avatar
    krockneedshelp Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 16, 2010, 06:04 PM
    Bathtub spout problems
    Hi there...

    We are trying to replace our bathtub set screw spout. After taking off the old one and replacing it with the new, we found that the pipe was too long and therefore leaving too much space between the spout and the tub. After trimming the pipe down and shaving off the rough pieces on the pipe, the spout fit. HOWEVER, there is now water coming out from behind the spout (on the wall) and an irregular water pattern coming out from the spout.

    Any help or bits of information would be appreciated! THANKS IN ADVANCE!:)
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #2

    Jan 16, 2010, 06:15 PM

    Sounds like the O ring is damaged, you need to remove the spout, check the O ring for damage or twist, you may need to replace the O ring or the spout it self, when you install it back make sure to use some lubricant on the pipe, good luck.

    John
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #3

    Jan 17, 2010, 10:59 AM

    I agree with John. You must be very careful when slipping new spout onto the pipe. I would suggest you take a file and file its edges so they are not sharp. Proceed as John suggests.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bathtub spout replacement [ 1 Answers ]

Is spout offset equal on all spouts

Replacing leaking bathtub spout [ 1 Answers ]

Have made a couple of attempts to replace a bathtub spout. The current spout leaks so bad that there is very little pressure to the shower. The diverter is leaking through the top of the spout and shooting a stream of water up into the air. The problem, when I remove the current spout (unscrew it)...

Removing stuck bathtub spout [ 1 Answers ]

I am trying to remove a bathtub fill spout that has a pipe thread near the water outlet. With a mirror I can see the end of what looks like a copper male threaded fitting. It looks like it has plenty of calcium/mineral buildup. I am hesitant to apply too much force with a lever since the...

How do I remove an old bathtub spout? [ 1 Answers ]

I want to replace the bathtub spout with a new one available at hardware store. I tried unscrewing the old spout barehanded and it won't budge. Can I use a wrench (I don't care if the old spout is marred), or is there a danger of breaking the pipe in the wall. I do NOT have access to the...

Removing bathtub spout - no hole [ 5 Answers ]

Hi, I have read the Q/A's on the site, but can't find an answer to this one. First, I have a Delta faucet. It looks like Delta Faucet T13422-SOS on the www.deltafaucet.com website. (There are a few more that look like this, but it has the diverter plug on the spout.) The difference is that...

View more questions Search