Ask Experts Questions for FREE Help !
Ask
    macgiver67's Avatar
    macgiver67 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 9, 2010, 09:09 AM
    Furnace stopped working
    Hi, I am getting 7 red flashes on the status indicator light for my Luxaire furnace, model GM9S060B12UP11G. The Diagnostic Fault Codes indicate "ignition lockout due to retries". The ventor motor starts as do the burners, there are several clicks heard and then the whole thing shuts down. The whole process lasts about 2 minutes and 20 seconds and the air fan never starts (it does spin freely by hand though). What is the likely cause of the problem? Thank you.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jan 9, 2010, 10:46 AM
    Turn off power at switch or breaker,, 1 minute turn back on,, watch it close,if it fires up and goes right back out,, try cleaning the flame senser with steel wool or very fine sandpaper

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kirkland Signature, by whirlpool; Dryer stopped heating and timer stopped working [ 2 Answers ]

I have a Kirkland Signature, by whirlpool Dryer that stopped heating and timer stopped working at the same time. What may have caused this?

Carrier stopped working [ 1 Answers ]

My carrier air conditioning unit has stopped working. I've done standard troubleshooting but nothing has worked. Thermostat appears to be working fine. I'm not getting any air blowing or ticks or anything when I adjust the thermostat. Could it be the compressor? Greg

Trane Gas Furnace just stopped working [ 2 Answers ]

I have a Trane XL80 gas furnace. It also has a heat pump for ref. Today, the temp in our home dropped and I noticed that the furnace was not working. I opened it up, and vacuumed it out, and have no idea why it started working. All was good! However, hours later, the temp is again...

Furnace stopped working. [ 1 Answers ]

Unfortunately, it seems our furnace stopped working a couple of days ago. I can get the fan to work if I set it to "on" but not "auto". And even if the fan is blowing in the "on" setting, the air never warms up. I've tried playing with the thermostat and resetting the whole thing a few times from...

Previously working electrical outlets stopped working [ 2 Answers ]

Hi Everyone A wall of electrical outlets in my kitchen just stopped working. They were working just fine about a month ago. I tried checking the circuit box, and turning the circuits on/off just to make sure anything that has been tripped was turned on back again. But it didn't work for the...


View more questions Search