 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane xe80 manual
My Trane XE80 will ingnite, shut off, ignite, shut off. Cleaned the flame sensor and still have problem that blower motor doesn't come on, but it sounds like it is trying to come on. Could this be the startup capacitor?
Also found the diagnostic light - which gives 4 blinks, indicating "Thermal Protection Device Open". What device could this be? Would greatly appreciate help, as the temperature is down to 65F inside and below freezing outside. |
||||
Check out some similar questions!
All summer the cooling worked fine, when I switch over to heat this week, it didn't come on. The control box shows a code 4, which says "THERMAL PROTECTION DEVICE OPEN" Any help?
The Trane XE A/C unit in the attic for the second floor stops running after apparently random times. Turning off the manual power switch to the unit for about 15 seconds enables the unit to start back up again. It appears to happen once it starts warming up, but then again it has run a couple of...
My 10 year old Trane XE80 in my woodworking shop lately cannot put out enough heat to satisfy the thermostat, which yesterday was set at 72 degrees on a 37 degree day. The steel building is completely insulated, and this has never happened before at this outside temperature. The furnace seems to...
My thermostat calls for heat, but the blower just comes on and blows air. No heat until I go down and manually restart the furnace. Any suggestions?
My thermostat calls for heat, but the blower just comes on and blows air. No heat until I go down and manually restart the furnace. Any suggestions?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
