 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Cache:KhbFs3bSQjAJ:www.askmehelpdesk.com/heating-air-conditioning/water-furnace-induc
I have a RPJ II Comfortmaker natural gas forced air upflow furnace about 14 years old. In the last month the thermostst will cll for heat the induction motor will run but the furnace won't light. A repair man came out and found condensation in the rubber lline that runs from the induction motor to a switch (pressure?) that tells the burner it's OK to fire. Pull the line off blow the water out . Put it back on and it's good till next time? Hours. Days. Sometimes more. Question is Where is the moisture coming from and ow can I stop it? The repair guy said he had no idea could be the flue pipe. Didn't know? Any ideas?
|
||||
Check out some similar questions!
Last winter I installed a programmable thermostat and everything was working fine. When summer arrived I switched it over to cooling and it was working fine all summer. I just switced the cooling off and left the thermostat in the off position. When I went to check the temp a few days later there...
My ruud Heating & Air Conditioning system is not blowing hot air, everything is working fine but not blowing hot air when I put it to heat
I have a honeywell dial thermostat and when I turned it up the other day the heat came on for about 5 min then shut off. Now the furnace doesn't go on anymore.I took the casing off and the mercury looks good. How can I tell if it is the furnace or thermostat. Also I noticed late this summer that...
How to test a 120 to 24 volt transformer can you use ohms if its out of the system?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
