 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant 383kav code 33
I am having issues with my Bryant 383kav furnace not heating. The LEDs show an error code 33. However, this code does not change to code 13 as the manual says it should after 3 minutes. The blower always turns on. The igniter also seems to be fine and does come on for a couple of seconds during the component test. Any ideas how I should go about troubleshooting the problem?
|
||||
Check out some similar questions!
Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...
Hello, I have a Bryant gas furnace 383KAV that is 7 years old. Currently the burners come on and then go off after a few seconds. After this happens 4x the furnace delays for 3hours. I thought the flame sensor might be dirty - but I cleaned it some and nothing came off. That didn't help. Filter...
Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...
After reading a couple of posts, I cleaned the flame sensor. When that didn't work, I bought a new one and installed it. I am still getting the same code. The burner lights for approximately 3-5 seconds, then cuts off. The thermostat is calling for heat. What am I missing?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
