Ask Experts Questions for FREE Help !
Ask
    reddolphin's Avatar
    reddolphin Posts: 8, Reputation: 1
    New Member
    		  
    #1

    Dec 31, 2009, 05:45 PM
    Driver rear sliding door won't open
    1998 Oldsmobile Silhouette, 3.4L 6 cyl. 2 wheel drive. Location is Missouri.

    At times it has been hard to open, like it is stuck. Now, it won't open at all. It is unlocked.

    The handle moves, feels like maybe the handle is not attached to whatever it is supposed to be attached to in order to open the door.

    Can't try opening from the inside because the child safety lock is turned to the on position.

    Was wondering if it is possible to remove the door panel while the door is closed. If so, is there a good website that shows how or a book that I can purchase at AutoZone or somewhere?

    Thanks in advance for any help.
    rosemcs's Avatar
    rosemcs Posts: 325, Reputation: 47
    Full Member
    		  
    #2

    Jan 2, 2010, 10:09 PM

    This happened to a relative too. It's extremely difficult to close and it can only be opened with the engine off.

    Maybe this website can help.

    Search - FixYa.com
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Glass sliding shower door very squeaky to open/close [ 2 Answers ]

I have a very standard glass shower door that opens & closes on a normal roller-ball track (sideways). But it has become very squeaky over the past couple of months (it's only about 1.5 years old). It doesn't appear to be the track that's squeaky, but instead the rubber seal that runs vertically...

Warped sliding glass door frame causes door to stick. [ 5 Answers ]

The center of our 8 foot sliding glass door bends out about 3/8 inch more than the two ends causing the door to wedge against trim that keeps the door from falling out when the door is closed making it difficult to open the door. How do I get the center of the door frame into place so the door...

Rear axle on my hydrostat mower is sliding out! [ 2 Answers ]

I have a riding lawn mower and the rear axle is sliding out. How do I go about repairing this? It appears to be held in with a clip at the end of the axle which would require me taking the hydrostat rear end apart to fix. Any advice or information would be very helpful. Thanks

View more questions Search