Ask Experts Questions for FREE Help !
Ask
    dynamic94's Avatar
    dynamic94 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 12, 2009, 12:29 PM
    Hunter thermostat not reaching set temperature
    My hunter thermostat model 47110A is set to 20 degrees celsius but the furnace will not stay on long enough for the temperature to rise to the set degree. It is currently holding at 16 degrees instead. The batteries are brand new but still the temperature will not rise.
    This is my first home so any tips or suggestions would be great.

    Thank you
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Dec 12, 2009, 01:37 PM
    We need the model number and brand of furnace,, could be you need to clean the flame senser, but if its electric you won`t find one,, more info please
    AJIII's Avatar
    AJIII Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jun 30, 2012, 04:25 PM
    Lenox ml180h series
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heater Shuts off Before Reaching Set Temperature [ 5 Answers ]

I have a goodman a/c with electric heat strip (10kw) and vey recently it stated to turn off before reaching the set temperature. After a few minutes it will restart and run for a couple of minutes and then shut down again without reaching the setpoint. It always stops at 66 on the white rogers...

Burnham Boiler not reaching Thermostat set point [ 1 Answers ]

I have a Burnham series 2a gas boiler. This morning we woke up to a temperature of 66 degrees. The set point for the honeywell thermostat is 72 degrees. Since I have been home, the boiler will kick on and shut off when the temp reaches 67. I have increased the set point to 78 degrees and yet it...

Temperature increases even after reaching programmed temperature [ 3 Answers ]

I have a NOMA thermostat (model 52-2558-8). After reaching the programmed temperature, the furnace stays on without shutting down (8 degrees before I manually shut it off). Is this a thermostat issue or a furnace problem?

Furnace not reaching set temperature [ 1 Answers ]

Similar problem Chickendoc has. The pemperature lebel shown in the thermostat is 67 while the setting is 72 when it stops. The furnace run short period of times. Some times it re-starts a few times stopping/re-starting succesively at same period of times. Finally, it gives up. What we are doing is...

Furnace shuts off before reaching thermostat setting [ 1 Answers ]

I own a Clare furnace model CHU 072 NH3A that runs for three minutes then shuts down for five minutes then restarts again. It has a primary limit switch and a burner limit switch. Any help would be appreciated. Thanks

View more questions Search