Ask Experts Questions for FREE Help !
Ask
    brian.luke74's Avatar
    brian.luke74 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 11, 2009, 03:44 PM
    Gas valve replacement
    I have an empire heater and need a new gass valve, r-1624 empire says they no longer make them they are obsolete. Are there any that are that will work in its place.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Dec 11, 2009, 06:40 PM
    I`m sure,, take it with you and go to local HVAC supply house,, they might /probably won`t sell you one but they might tell you what you need for replacement
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

TX valve replacement? [ 2 Answers ]

I have a Trane XL1000 and a serviceman indicated that the TX valve needs replaced or he said it might be best to buy a new unit. The unit is about 17 years old but was working fine until this. He indicated that there are no way of knowing how long a replaced TX valve would last since there is a...

White Rodgers gas valve 36e troubleshooting [ 3 Answers ]

I have a Lennox G23 furnace with a White-Rodgers 36E24-204 NG valve that continually is tripping the limit switch, due to a condition where the pilot is putting out way too much flame. I can see areas on the plate where the limit / rollout switch sits, and the flame has deposited large amounts of...

Gas Valve Replacement opinion? [ 4 Answers ]

Hi everyone, I have a busted gas valve on my furnace. It is an American Standard furnace that is roughly 25 years old. I have been seeing Honeywell gas valves that are universal that states that they can replace an american standard standing pilot 24volt gas valve. It seems to have the right...

Gas valve replacement [ 1 Answers ]

I also have been having issues with my gas furnace. Apparently the needle valve inside is not working properly says the furnace repair man. He told me the valve needed to be replaced. Is this a part that can be easily removed and replaced by myself. I am a engineer if u care. What do I...

Supply valve replacement [ 4 Answers ]

What is the best way to remove the nut and compression fitting on a sink supply valve?

View more questions Search