 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have installed a new Flotec Bladder Tank
I installed a new Flotec Bladder Tank. Luckly no leaks. I have set the tank to the specs of the pump... 20/40 (2 below) on... it ran great for a few minutes. thinking it was builing up pressure... But there is no water pressure. What am I missing? Help!
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Does anyone have any tips or additional instructions? We're replacing the bladder in our Flotec FP7110T-04 42 gal. water pressure tank. We have the new bladder, expensive !@#$%^&*! That it is. No instructions came with it. The old one ruptured. Water came out the air valve. The plan is to: shut...
We just had a new well put in. The well person installed a 220 gallon storage tank (not bladder) when we turn on our sprinkler system our submersible well pump cuts in every 50seconds. We are using approximately 16 gallons per minute. Should the well person have put in a bladder tank instead of a...
Hi, I need to replace a Bladder tank in my home. I have a well system with a submersible pump. The copper connections seem quite simple with regard to replacing etc. However, I've done some on-line research and the more I read the more difficult the installation seem to be. My question is about...
Just install a 19 gallon pressure tank to pump.set tank pressure at 28lbs was not able to get water to go into tank.water would come out of water faucett.lower pressure in tank to 20lbs was able only to get about 3 gallons in tank running the pump for appx 5 minutes.does this sound like the pump is...
Hello, thank you for attempting to help. I have a little water pressure in the morning, but after running the dish washer I have just a trickle. I have looked at the gauge at my tank and I can't get above 15 psi. I have also turned the power of to the submersival pump, turned the nearest faucet on...
View more questions Search
|
