Check out some similar questions!
Replacement furnace blower motor compatibility
[ 4 Answers ]
My dead 20 yr old Weatherking furnace blower motor is a 1/2 hp four speed, 1075 rpm Westinghouse. Brown and white wires go to capacitor, with yellow (med low) and black (high) connected, and blue and red capped off. Motor schematic shows white and yellow as line wires. Proposed new motor (AO...
Blower Motor Replacement
[ 1 Answers ]
How do I replace a blower motor in a residential gas furnce?
Replacement Furnace Blower Motor
[ 4 Answers ]
Hi, I have an older (~40 years, the original with the house) Coleman furnace. The blower motor (General Electric, 1/6 hp, 110 V, 60 Hz, 3.6 amps, PH 1, 1725 rpm) burnt out the other morning. I went to the local shop (RONA) to find a replacement and they didn't have the exact motor. Instead,...
Replacement blower motor wiring
[ 1 Answers ]
I purchased a replacemet fan motor for an older rheem heat pump. The wiring is different from the original. There are 2 browns for the capacitor, one green to ground, a black common, and a yellow one labeled "line". Where does the yellow wire connect? The old one had 2 for capacitor and one common.
Furnace Blower Motor replacement
[ 3 Answers ]
I have a Comfortmaker furnace with General 90 controller. My blower motor stopped working and when I try to turn it on it gets hot, smells like something burning and no air. Capicator was tested and it is OK. Motor is driving excessive current and just heats up. HVAC technician quoted $700 to... View more questions Search
Add your answer here.
|