Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Shower basin removal
[ 1 Answers ]
I am trying to remove a shower basin from my basement. It is set on concrete. The basin is fiberglass. The pipe coming from the floor is iron (rusty too). How is the basin attached to the pipe? Adhesive? Is something screwed down? Help? Thanks. Christina
Shower making high pitch whistling noise
[ 4 Answers ]
My shower makes a high pitched whistling noise. This doesn't happen all of the time, and seems to be more pronounced when changing the temperature from hot to cold. It may come and go, or may make the noise during the duration of the shower. Any thoughts on what could cause this? Any help would...
Pre-fab shower basin
[ 3 Answers ]
I have a pre-fab shower basin I'm putting on the ground floor bathroom. The last shower there would back up every one in a while and the waste use to leak under the basin. Is there a way to seal the pipe so if the pipes backup the water goes back into the shower and not under the basin. The last...
Leaky shower basin
[ 3 Answers ]
I just redid my second story shower and put a new subfloor under the basin. The basin needed the pipe to be exactly in the middle so the rubber boot would stop the water. It was a little off so the boot went on and I siliconed but it is still leaking so now I have to break the ceiling downstairs....
Shower Basin Drain
[ 5 Answers ]
Hi, Tom was asking for more info but I wasn't registered, took care of that. NOW question is how is the flange removed from my old shower basin. I removed all tile sheetrock and basin to replace it with a four piece fiberglass unit. I can not remove the flange. Here is what I know: The drain is a 2... View more questions Search
|