 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a 2007 Bryant Plus 90t Furnace and since it was installed 1n 2007 the Flame Sensor had to be cleaned 3 times, what's the problem why does the flam sensor get corroded and the furnace won't light.
I have a bryant from 1991. When I turn up heat the fan starts then ignitor starts, lights pilot and will run like that for about 5mins then shuts down and won't try to relight until I reset the power. When the pilot lights the flame is kind of weak. The blower is blowing it hard and it will...
The fan will not shut off unless I shut off the gas switch . Just changed the thermostat only cold air is coming out Any ideas
I have a bryant gas furnace model 383kav038070. I get trouble shooting code 12. What has failed. I do not have code table
I have a bryant gas hot air furnace model #397HAW036100. It has been nothing but trouble since day 1. here's my problem this year again. Purge fan kicks on gas valve goes on to pilot lights. Clicks on gas valve and pilot goes out. Does this about 6 times before it locks out. Last couple years...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
