Ask Experts Questions for FREE Help !
Ask
    ramon tem's Avatar
    ramon tem Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 6, 2009, 07:32 AM
    Blower for interterm furnace
    Furnace works good but blower rattles a lot, I check for any loose parts but it looks like
    Everything is in place sometimes it rattles as soon as it starts running other times it takes a little while runs good but it goes back to making noise
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Dec 6, 2009, 07:36 AM
    Dirt and debris in the blower wheel is the most common culprit. To most effectively clean the wheel, it must be removed from the housing and thoroughly sprayed with water.
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

T-start fan on/furnace blower on, AC w/fan on/auto, blower off [ 8 Answers ]

If no cool or heat, just fan on, there has blower start in furnace; While in air conditioner, regardless fan on or auto, there will be no indoor blower on at all; While outside condenser and its fan seems fine. I lready jump wires G, RC and Y in T-start, won't see any difference. By the...

Furnace Blower Motor Runs Constantly & Furnace or AC Won't Run [ 2 Answers ]

I have an Armstrong forced air (induced draft) natural gas furnace with central AC (made around 1990 -- Model: EG6H80DC14-1, Serial: A18315MNA). I had a problem at the end of the heating season where the blower motor would run continuously (even when the thermostat is turned to "off"). I thought...

Furnace ignites but blower won't start till furnace shuts down. [ 7 Answers ]

(Nordyne/Miller G3RA)-I have a furnace HSI(glow plug) that will ignite and burn until it gets too hot and shuts down. As soon as the furnace shuts down the blower starts to circulate air. The blower circulating air cools the furnace and it reignites.Shortly after the furnace ignites the blower...

Blower furnace [ 1 Answers ]

The heating Blower shuts on and of any remedy to set the relay

Furnace blower won't come on [ 1 Answers ]

I have a Conquest funace {1994}. When I turn up the thermostat, the exhust fan will come on and then the burners will come on. Next I will hear a "click" but the blower fan won't come on. I replaced the motor and copasiter but to no avail. Any ideas?

View more questions Search