Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Low profile p trap?
[ 2 Answers ]
Has anybody seen one of these? I found them on a wholesaler web site but have not been able to find one at any retailers. Reason I"m looking for one is that I want to install a shower in an upstairs on 2 x 6 joists. The 2" p trap that I found at Home Depot needs about 8" to make it work. I...
Toilet replacement and floor height change
[ 1 Answers ]
I am going to be setting a new toilet in our addition and need help. I needed to level the floor as there was over an inch and a half between the old and new areas of the bathroom. After all is said and done, the old cast iron flange is almost two inches below the new floor height. During...
Toilet flange too low
[ 1 Answers ]
I discovered a leak in the base of the upstairs toilet that had soaked the subfloor and cause the tile to come loose. I removed the tile and discovered that it had been set on a plywood backer. I removed the plywood and cut out the rotting wood around the toilet. This exposed the ABS plumbing...
My children's father (babydaddy) hates my guts
[ 1 Answers ]
Thanks for advice
PVC toilet mount and flange replacement on slab
[ 3 Answers ]
Hi. I'm a new home owner and an idiot. I discovered that our toilet on the first floor (no basement) was rocking back and forth, and upon attempting to tighten down bolts, further discovered that they spun freely. I removed the toilet to find that both slots of the pvc mount were broken. ... View more questions Search
|