Ask Experts Questions for FREE Help !
Ask
    fmarron's Avatar
    fmarron Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 4, 2009, 02:26 PM
    Replacing headlight and parking light in a ford ranger
    Hit a deer.both the headlight and the parking light kit needs replacing how does this work?99ford ranger.Thanks
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Dec 4, 2009, 06:19 PM

    I'm not sure if this is applicable to your model truck or not. Here's how it's done on many Ford products:


    1. Remove mounting bolt near the front grille (8 mm).

    2. Pry up both retaining slides (look for two rubber-coated tabs), located on the rear of the headlight housing, with a screwdriver.

    3. Pull the housing outward, disconnect the electrical connector from the headlamp bulb, and remove the housing from the vehicle.

    4. Remove and replace the headlamp and amber turning signal, after cleaning the connectors with WD-40.

    5. Button things up.

    6. Adjust headlamps with the vehicle parked level, gas tank half full, and nothing in the truck.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing brake light switch on 1995 ford falcon [ 3 Answers ]

:) We have a 1995 Ford Falcon. The stop/brake light switch is caput. We have replacement but need info as to how to install it. Anyone out thyere who can help these 2 old codgers please??

How to replace headlight bulbs on 1999 ford ranger [ 4 Answers ]

I am having a hard time trying to replace the bulbs in 1999 ranger headlights, I 'm not sure how to gain access to the old bulbs. I can't find any screws to loosen, so I can pull the headlight assembly out far enough to get to old ones. We just bought this truck and came with no manuals. I feel...

Ford Ranger [ 1 Answers ]

2001 Ranger. I found dangling down from left side rear a hose with a cilp. It was attached to the axle housing. What is it for and where does it go. It just appears to be some type of air hose but is not attached to anything at other end. Should I be concerned? Thanks

92 Ford Ranger 2.3L [ 1 Answers ]

Anyone, what problems does the Check Engine light going on usually indicate? I was coming home tonight, about an hour highway drive and the light momentarily came on, then off, on and off. Not a flicker, but for several minutes at a time. Truck is VERy reliable and there is no indication that...

View more questions Search