Ask Experts Questions for FREE Help !
Ask
    quentin kolar's Avatar
    quentin kolar Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 1, 2009, 07:48 PM
    Base board heaters can I run two of them on a 20amp double pole breaker
    Can I run two baseboard heaters on one 20 amp double pole breaker
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Dec 1, 2009, 07:52 PM

    Wattage? Voltage? Of each

    Thermostat contact rating in amps?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Base board heaters [ 2 Answers ]

I'm try to hook up a baseboard heater with a thermostate the heater has a balack and red wire and the thermostate has a black and red but the 12-2 wire has black,white and ground ,I try to hook allblacks together and all reds to the white and it didn't work can someone help me with this hook up

Wireing base board heaters [ 1 Answers ]

I am dividing a room by putting up a wall. As a result I need to add heater. My question is it possible for me to add on to the existing run and use this circuit to power the new heater? Will there be enough power to operate the new heater and does this run a risk of fire. This is a new...

20amp QUAD double pole versus 2 20AMP tandem single pole [ 2 Answers ]

I have 5 zones of baseboard heat, 3 of which were disabled due to the addition of a heat pump. The circuit panel is full and would like to restore the operation of the 3 zones of base boardheat. I was planning on removing 3 double pole 20amp 240 volt circuits and installing 3 QUAD 20 amp double...

One pole of untied double-pole circuit breaker breaks [ 5 Answers ]

I recently purchased a new dryer (220 v appliance) to replace an older model. The old dryer was connected to the panel via a double-pole breaker except that there was no clip or tie between the poles. I changed the location of the outlet when installing the new dryer, replacing the cable with the...


View more questions Search