Ask Experts Questions for FREE Help !
Ask
    kennyc537's Avatar
    kennyc537 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 29, 2009, 07:51 AM
    Installing drains on copper shower pan
    I have new copper shower pan and need to transition to 2 pvc pipe and cannot disturb floor below what is best way
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Nov 29, 2009, 09:02 AM

    Please explain with more detail. Transition from what to PVC? Was there a flange type,(see image) shower drain lower part installed before the pan was formed? What's sticking up out of the drain at the present time? Back to you, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to take out shower pan and not damage drain [ 12 Answers ]

Hi, I am trying to remove this old shower pan without damaging the drain. I can not tell from looking at it how it is fastened to the pan or to the floor beneath the pan. When I pry up the pan a little bit, the drain seems to move with it. However, I didn't want to go too far for fear of...

Shower Pan [ 6 Answers ]

Ok, I've been reading a lot of the questions and answers and still am slightly confused. I set the drain(adjustable) after chiseling away concrete and cutting existing drain pipe(from previous fiberglass shower). The lower flange is slightly recessed below floor level(local plumber advised this)to...

Correct way of installing a vinyl shower pan [ 12 Answers ]

What is the proper way to install a new vinyl shower pan? Is it wrong to screw through the pan and cement into the marine board on the wall side? Won't that cause leaks eventually? I read that nothing should be screwed in below 8" of the bottom of the wall. And is there a special screw that needs...

Installing Shower Drain Where Old Copper Corroded [ 1 Answers ]

I have an old shower pan that had a corroded copper drain. (Completely Corroded through so that there was some pieces left in the brass trap connection.) I was wondering if PVC can be connected to the brass or do I need to solder new copper. These are 2 1/2 inch pipes, so I'm trying not to spend...

View more questions Search