Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
BX to Romex?
[ 12 Answers ]
I have an older home with the metal sheilded 2 conductor cable. 2 20 amp lines were added to the kitchen, but still using the metal sheilded 2 conductor cable. Is it OK to connect this in a box to romex? The kitchen is being updated again. I am very handy (ex automechanic) and will add one...
Allowable # of romex in a 2" romex connector
[ 2 Answers ]
Hi, I would like to know the maxamum allowable romex wires can be secured in a 2" romex connector. Thanks
NM-B Romex for spa
[ 17 Answers ]
I am running NM-B #6 3 wire w/ground from my panel to a J box that exits the house (all indoors at this point). From that point I have about a 40 ft. run to the spa. I have trenched and laid conduit for the remainder of the run. Can I remove the sleeve on the NM-B Romex and use this wire for the...
15A vs. 20A on #12 Romex
[ 10 Answers ]
We are running #12 Romex wire for circuits from the panel. I want some of the breakers in the panel to be 15amp and some to be 20amp. My electrician says that they should all be 20amo because #12 Romex is code for 20 amps. I said sure but it shouldn't matter is we go smaller than code (i.e....
Bx or romex 240 or 120
[ 5 Answers ]
Replacing old bathroom fixtures in a 100 yr old house. Has old 2 wire bx and I want it on its own circuit. The supply comes in from another room to the ceiling box where it goes to another room and to the wall switch then from there it goes to the medicine cabinet. I want to have this room on its... View more questions Search
|